AirTies WOB-201 Instrukcja Użytkownika Pobierz pdf (Strona 20)

3.2.3.

Point-to-point (P2P) Connection Settings

This section describes how to configure the WOB-201's on two ends of a point-to-point

connection. We'll refer to the two end points as "point A" and "point B".

Before you start with the configuration, the hardware installation of the WOB-201's at

"point A" and "point B" should be completed.

To set up a point-to-point connection with the WOB-201, you need to configure the Mesh

settings. There is two ways to configure the Mesh settings: Manual or AutoMesh. To select

the mode for Mesh configuration go to Mesh Settings under the WIRELESS NETWORK main

menu.

Initial Settings at Point A:

1) Login to the WOB-201 Web interface. Make a note of the MAC Address that you'll

find on the "WELCOME" screen.

2) Go to IP Settings under the LAN menu.

Point-to-point (P2P) Connection Settings Using AutoMesh

Technology

The WOB-201 is set up as an "Access/Mesh Point" by default.

AirTies WOB-201 User Manual

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Brak uwag

AirTies WOB-201 Instrukcja Użytkownika Strona 20